From pH S8 cable socket to VP8 male cable socket

AS8 connector on cable from analogue pH sensor with S8 male socket to VP8 male (VP6 active). In total 200 mm long.
Check out part number under Commerce.

From pH K8 cable socket to VP8 male socket via cable

AK8/9 cable connector connects to analogue pH sensor with S8/9 male. Cable supplied with VP8 male (VP6 active). In total 200 mm long.
Check out part number under Commerce.

pH sensor S8 socket to K8 socket (the little red adaptor)

Allow the pH sensor style S8 socket to be used with cable connector style K8.
Check out part number under Commerce.

OneFerm VP6 analogue pH sensor to digital ARC VP8 adapter

Hamilton ARC digital signal module fits the analogue SUS OneFerm VP8 male (VP6 active) combined pH / NTC (22kOhm). Converts the two analogue signals to one corrected 4-20 mA pH signal and 2 digital signals (corrected pH and °C) for ModBus communication with PCS. Be sure that the correct Modbus address from 0-10 is used.

Check out part number under Commerce. 

www.hamiltoncompany.com/sensors/single-use-sensors/arc-module/arc-module-su-ph

VisiFerm analogue VP8 converter to old D4 socket

In case you have an older PCS with T82/D4 cable connector originally for use with polarographic DO sensor. This adapter allow use of the modern VisiFerm VP8 analogue sensor combined with the VisiWell DO pre-installed in SUB or SUF. Operates from 110-240 VAC (Hamilton p/n 242413).